Raise sunken driveway slabs, improve uneven transitions, and address settled concrete without automatically replacing the entire driveway.
Idaho Drainage and Foundation Repair provides driveway concrete leveling in Boise and throughout the Treasure Valley using polyurethane concrete lifting technology.
If the existing driveway is still in usable condition, polyurethane can be injected beneath settled sections to fill void space and raise the concrete toward the intended elevation.
We also look beyond the visible low spot. The condition of the slab, garage transition, neighboring concrete, support beneath the driveway, and surrounding drainage all help determine whether lifting is the right repair.
Tell us what's happening and we'll schedule your on-site evaluation.





Driveway settlement often shows up as a change between two surfaces rather than the entire driveway sinking uniformly.
Common signs include:
These symptoms do not automatically mean the driveway can or should be lifted.
The condition of the existing concrete still matters.
One of the most noticeable driveway problems occurs when the exterior slab settles below the garage entrance.
The garage floor or threshold remains at its existing elevation while the driveway drops, leaving an abrupt transition.
That difference can be noticeable when:
If the exterior driveway slab remains suitable for repair, polyurethane lifting may allow it to be raised toward the garage elevation.
But the garage creates a fixed reference point.
The repair has to consider the garage floor, adjacent driveway slabs, existing cracks, nearby sidewalks, and the direction water needs to travel.
Concrete depends on the material beneath it for support.
When support changes beneath one section of a driveway, the slab can move downward relative to surrounding concrete.
Possible contributors include:
If fill beneath part of the driveway compresses more than the material around it, the concrete above can settle.
Loss of contact between the concrete and underlying material can leave unsupported areas beneath the slab.
Moving water can sometimes remove supporting material near or beneath slab edges.
Roof runoff, irrigation, and surface drainage may affect conditions around a driveway.
Water is not responsible for every settled slab. It becomes more relevant when the water path and settlement occur in the same area.
Excavation, utility work, landscaping, grading changes, or other disturbance can create different support conditions beneath sections of a driveway.
It can contribute, but the connection should be evaluated rather than assumed.
For example, suppose the corner of a driveway has settled beside a downspout.
The downspout may be affecting support conditions around the slab.
Or the driveway may have settled for another reason and the downspout simply happens to be nearby.
We look for conditions such as:
When drainage appears relevant, correcting the water path may be recommended separately from raising the concrete.
Idaho Drainage and Foundation Repair uses a professional HMI polyurethane concrete lifting system.
HMI’s process injects dual-component polyurethane beneath settled concrete. The material reacts and expands beneath the slab, filling available void space and creating controlled lifting force.
We begin with the affected slabs and surrounding surfaces.
The evaluation may include:
The first question is whether the existing driveway is a reasonable candidate for lifting.
A settled driveway slab needs something to align with.
That may be:
The target elevation is established before lifting begins.
Small access holes are drilled through the driveway.
HMI’s standard polyurethane concrete-raising process uses approximately 5/8-inch injection holes.
Polyurethane material is injected beneath the concrete through the access points.
It enters beneath the slab as a liquid and expands as the components react.
As the material expands, it occupies void space and creates lifting force beneath the slab.
Material can be introduced incrementally while the technician monitors movement.
The slab is checked relative to the garage, neighboring panels, sidewalks, and other fixed elevations.
The access holes are patched after the lifting process is complete.
Polyurethane concrete lifting offers several practical characteristics for driveway repair.
HMI’s polyurethane process uses approximately 5/8-inch access holes, which are smaller than those traditionally associated with mudjacking.
Polyurethane lifting material is considerably lighter than the cementitious slurry used in traditional mudjacking.
The technician can introduce material incrementally and monitor how the driveway responds as it moves.
Expanding polyurethane can fill available void space beneath the driveway while creating lifting force.
The objective is not simply to pump material beneath the concrete.
It is to use controlled injection to reposition a slab that has been determined to be a reasonable lifting candidate.
The fact that a driveway has sunk does not automatically mean it needs to be demolished.
The more important question is the condition of the existing concrete.
Polyurethane lifting preserves the existing concrete.
It does not give the homeowner a new driveway surface.
For a more detailed comparison, see concrete leveling versus replacement.
Sometimes.
A crack does not automatically disqualify a slab from lifting.
The condition and configuration of the concrete matter more than the mere presence of a crack.
A relatively intact slab with a crack may still be a reasonable candidate.
Concrete that has broken into numerous unstable sections may not be.
It is also important to understand what leveling does not do.
Raising a driveway does not erase:
Concrete leveling corrects elevation where feasible. It is not concrete resurfacing.
It can help when settlement of the driveway is what created the low spot.
Suppose one slab settles while the surrounding concrete remains higher. That change can create a depression that collects water.
Raising the slab may improve the surface drainage path.
But driveway puddling can also involve:
In those cases, lifting one slab may not solve the complete drainage problem.
Idaho Drainage and Foundation Repair can evaluate whether the issue is primarily concrete elevation, exterior drainage, or a combination of both.
For larger water-management problems, see yard and exterior drainage services.
Both polyurethane lifting and traditional mudjacking are designed to raise settled concrete.
The methods use different materials.
Mudjacking generally pumps a heavier cementitious slurry beneath the concrete and traditionally requires larger injection openings.
Polyurethane is injected beneath the slab as a liquid and expands.
HMI’s system uses smaller injection holes and substantially lighter material while allowing technicians to introduce material incrementally during the lifting process.
Idaho Drainage and Foundation Repair uses polyurethane concrete lifting for driveway leveling.
A settled driveway does not automatically mean the house has a foundation problem.
The driveway and home foundation are separate structures.
A driveway may settle while the house remains stable.
However, a different evaluation may be appropriate when driveway settlement appears alongside structural symptoms such as:
If the concern extends beyond the driveway, start with a foundation inspection.
Concrete leveling should not be used as a substitute for diagnosing structural foundation movement.
The objective is to improve the elevation and alignment of the existing driveway within the constraints of the surrounding property.
A perfect return to the slab’s original position cannot be assumed.
The achievable lift can be affected by:
The estimate should establish a realistic lift objective before work begins.
Driveway conditions vary from property to property throughout Boise and the Treasure Valley.
Relevant site conditions may include:
There is no single cause that explains every sunken driveway in the area.
That is why Idaho Drainage and Foundation Repair evaluates the actual slab and surrounding site before recommending lifting.
Driveway leveling cost depends on the scope of the project.
Factors can include:
Idaho Drainage and Foundation Repair provides free estimates so pricing can be based on the actual driveway rather than a generic per-slab assumption.
A driveway evaluation should determine more than how far one corner has sunk.
We may look at:
The goal is to understand what needs to move, what it needs to meet, and whether lifting is the appropriate way to get there.
FAQ